PRE ORDER OPEN JUNE 18TH - JULY 2ND

We made a new post. Because the old one, while good, just wasn’t good enough. This one’s lighter, stronger, and a whole lot meaner.

It’s built around a 3D printed titanium head— no shortcuts, just raw, printed, Tyler welded Ti wizardry. Then we got real nerdy and 3D printed the cradle and clamp hardware out of aluminum. Precision meets madness. All of it was obsessively engineered, tweaked, re-tweaked, and then field-beat into submission until it passed the “no excuses” test.

Zero offset or 15mm, take your pick. Some like it slammed. Some like it kicked back. We got you.

It’s buttery smooth as a titanium post should be. It’s simple. It works every time. And it’ll probably outlast the next three frames you mount it to.

Made with too much care, probably. Built to be a lifer.

PRE ORDER WILL START SHIPPING JULY 14TH

Specs

• 30.9mm Diameter

• Zero or 15mm Offset

• 350mm or 420mm long (rails to bottom of post)

• Compatible with 7mm round or carbon rails

• 75mm minimum insertion

Weight

• 240g (350mm)

• 270g (420mm)